If necessary, contact your local GP distributor. If the error occurs again, use the GP's self-diagnosis feature and identify the problem. Confirm that the port selected in corresponds to the serial port actually connected to the transfer cable.Īn error has occurred while writing the data to GP internal memory. Reset the GP and the PC and retry data transfer. The cable has been unplugged or GP's power supply may have been turned OFF. The screen with which Upload Information is not sent cannot be received. At the time of transfer, the screen may have been sent with in unchecked. Since there's no data in GP, which is required for receiving data, screens cannot be received. When an error occurs though data in GP are GP-PRO/PB3 for Windows95 version To receive data, use GP-PRO/PB3 for Windows95 version DOS Transfer Tool or GP-PRO/PB3(DOS) drawing software is required. No Upload Information on GP(When receiving data from GP)Ĭonfirm that the data in GP are not the screen transferred from GP-PRO/PB3(DOS).ĭata of GP-PRO/PB3(DOS) cannot be received by GP-PRO/PB3 for Windows95 drawing software. When the used PC is DOS/V machine and a conversion connecter is used because the serial port has 9 pin, confirm that wiring is correct. In the PC's system settings, turn OFF the power-saving mode. When the used PC is NECPC-9801 Note and a conversion connecter is used because the serial port has 14 pin half pitch, wiring may not be correct.Ĭonfirm that the used PC is NEC PC-9801 Note and the power-saving mode is not set. Open on the menu bar of Transfer Screen and change the setup method to and then transfer data. If an error is not avoided,even after confirming all above, try to perform Force System Setup. If it's in OFFLINE mode except the transfer mode, change it to the transfer mode.Ĭonfirm that it's firmly connected to the tool connecter on the GP's side and to the serial port on the PC's side.Ĭonfirm that the serial port does not have such settings that it's used as a modem or infrared ray. Solutions for each transfer error messageĬonfirm that the GP power supply is not turned OFF.Ĭonfirm that GP is not in OFFLINE mode except the mode of transfer to PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |